Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Cost in Melrose?
Garage door work in Melrose typically costs $150 – $600, depending on what’s actually failing. A spring repair usually runs $180 – $340 for a single spring, while a full new door installation lands between $700 and $2200. The written estimate sets the final price, and estimates are free.
That lead range covers most of what we see: a snapped torsion spring, a frayed cable, a track knocked out of line, or an opener that quit. When you call (877) 931-8297, we’ll walk through what the door is doing and book a visit. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
None of these are “starting at” numbers designed to get you on the phone and then balloon. They’re the ranges we see for the work in this part of the Bronx, and the estimate you get in writing is what you pay.
Key Takeaways
- Most garage door repairs in Melrose fall between $150 and $600.
- Spring repair is $180 – $340 for one spring; a matched pair is usually replaced together at roughly twice that.
- Cable repair runs $130 – $250, and track realignment $120 – $240.
- A new door installed is $700 – $2200, which often beats patching a door that’s already failing in several places.
- Free estimates, and the written estimate sets the final price.
Garage Door Cost Breakdown (2026)
Here’s how the work breaks down by type. Each range is typical for Melrose, and the written estimate sets the final price.
| Service | Typical Estimated Range |
|---|---|
| Garage Door Repair (general) | $150 – $600 |
| Spring Repair (one spring) | $180 – $340 |
| Cable Repair | $130 – $250 |
| Opener Repair | $120 – $320 |
| Opener Installation | $250 – $550 |
| Panel Replacement | $250 – $500 |
| Track Realignment | $120 – $240 |
| Roller Replacement | $110 – $220 |
| New Door Installation | $700 – $2200 |
A few things move the number up or down. A single spring is one job; if both springs are old and matched, we usually replace the pair together so the door stays balanced, and that costs about twice the single-spring range. Panel replacement depends on whether the panel is a stock size or a discontinued profile, and on the door brand – we work on Clopay, Amarr, Wayne Dalton, Raynor, and the rest, so a matching panel is realistic rather than a guess. Opener work depends on the system: a straightforward belt-drive LiftMaster or Chamberlain repair is a different job from tracing a dead logic board on an older Genie or Craftsman unit.
Installation is the widest range because it spans a bare-minimum single-car door all the way to a fully insulated double door with a new opener and hardware. Size, insulation, window inserts and material all count. For most people, the question worth asking is whether the existing door is worth repairing at all – a door with one bent panel and solid tracks is a repair; a door with rusted bottom sections, worn rollers and a tired opener is often a replacement.
What Affects Garage Door Pricing in Melrose
- Which part failed. A roller is cheap, a spring is mid-range, and a bent track that’s pulled the door out of square is a bigger job. The part itself usually matters less than how much of the system it took with it.
- One spring or a matched pair. Most double-car doors run two springs. If one is broken and both are the same age, replacing the pair is the sensible call, and that’s why a pair costs roughly double the single-spring range.
- Door brand and panel availability. We service LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor, so the panel or opener you already have is something we can source and work on without a mismatch. A door brand outside that list is a conversation before it’s a job.
- Opener type. A standard opener repair and a smart-home opener repair aren’t the same level of diagnostic work. LiftMaster and Chamberlain/myQ systems, plus legacy Craftsman and Genie units, all get handled, but the labor varies with how the system is wired and connected.
- Door size and material. A single-car steel door and a double-car insulated wood door are not priced alike, and the difference is mostly in the door itself, not the install.
- How far the damage has spread. A door that’s been run for months on a bad spring will usually show worn cables, stressed rollers and track damage too. Fixing all of it at once costs more than fixing one part, but it stops the second and third failures.
We also know that most Melrose garages sit behind homes where the door is the main way in and out. When it won’t move, the car is trapped and the house is open. That’s the reason our emergency work exists: a snapped spring, a door stuck open, or an opener that’s dead with the car inside. Spring failure is a safety issue, not just an inconvenience.
Repair or Replace? How the Numbers Usually Fall
The decision point usually lands around half the cost of a new door. If the repair estimate comes in well under that, fix it. If it’s edging toward half the price of a replacement, and the door is already showing age in its panels, hardware and opener, then replacing makes more sense – you get a door that’s matched front to back instead of a patchwork of new and old parts.
Here’s a simple way to frame it:
- One or two failing parts on an otherwise sound door: repair. A spring, cable, roller or opener repair is a clear win.
- Multiple failures at once, plus visible panel damage: compare the repair estimate to the $700 – $2200 installation range and weigh how long the door has left.
- Door out of square, tracks bent, and the panels don’t line up anymore: replacement is usually the cheaper long-run path.
We don’t push replacement when repair will hold. But if a customer is looking at a $500 repair on a door that’s going to need panels and an opener within a year, we’ll say so.
How to Save on Garage Door
The biggest saving isn’t a coupon – it’s catching a failing part before it takes the rest of the system with it. A worn roller set replaced at $110 – $220 is cheaper than a roller that seizes, jumps the track, and bends a panel. Same with cables: a frayed cable spotted early is a $130 – $250 repair, not a spring failure and a door dropped out of square.
Practical things that keep the number down:
- Fix the small stuff early. Listen for grinding, watch for a door that starts moving unevenly, and check that the opener isn’t reversing on its own. Those are cheap signals to act on.
- Replace springs as a pair when they’re matched and old. It reads like a bigger bill today, but it saves a second call later.
- Keep the door balanced and lubricated. A door that’s properly balanced puts less strain on the opener, the springs and the rollers, and those are the parts that cost money.
- Ask for the written estimate before any work starts. It should break out parts and labor so you can compare like for like.
- Get more than one number for a replacement. Installation ranges vary widely by door spec, so make sure the quote names the model, size and opener.
Estimates are free. Call (877) 931-8297 and we’ll talk through what the door is doing before anyone comes out. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Why Use a Specialist for Spring and Opener Work
Some garage door work is genuinely dangerous. The torsion spring above the door holds the full weight of the door under tension, and it’s under load even when the door is down. Cables are under the same tension. This is the part of the trade where a homeowner with a set of winding bars and a video can get seriously hurt, so it belongs with a trained technician – not a generalist handyman fitting it in between other jobs.
Our technicians have up to 13 years of experience on this equipment, and spring repair is a core part of what we do. The same goes for opener diagnostics: a LiftMaster or Chamberlain/myQ system, a legacy Craftsman or Genie unit, all of it needs someone who knows the model, not someone guessing at the wiring.
We also cover the full scope under one call: repair, spring repair, opener repair, installation and emergency service. If the door turns out to be beyond repair, the same company that diagnosed it can replace it. If you’re on the other side of the borough and need the same service, our garage door repair Mott Haven page covers it.
FAQs – Garage Door Cost
How much does garage door repair cost in Melrose?
Most garage door repairs in Melrose run $150 – $600. A general callout for a spring, cable, roller, track or opener issue sits inside that range, with the specific part and the extent of the damage deciding where in it you land. Call (877) 931-8297 for a free estimate – the written quote sets the final price.
How much does a new garage door cost installed in Melrose?
A new door installed in Melrose typically costs $700 – $2200, depending on size, insulation, material and whether an opener is part of the job. The estimate will name the door and the hardware so you’re comparing one spec to another. Call (877) 931-8297 for a free estimate.
Is it cheaper to repair or replace a garage door?
Repair is cheaper when one or two parts have failed on a sound door – a spring at $180 – $340 or a cable at $130 – $250 is a fraction of a replacement. Replacement makes more sense when the repair estimate climbs toward half the $700 – $2200 install range and the door has multiple problems at once. Call (877) 931-8297 and we’ll give you both numbers.
How much does garage door spring repair cost in Melrose?
Spring repair in Melrose is typically $180 – $340 for one spring. If your door has a matched pair that are the same age, we usually replace both together, which costs about twice the single-spring range. Call (877) 931-8297 for a free estimate on your door.
How much does garage door opener repair cost?
Opener repair typically runs $120 – $320 in Melrose, and a new opener installed is $250 – $550. The range depends on the system – a standard LiftMaster or Chamberlain repair is a different job from a legacy Craftsman or Genie diagnostic. Call (877) 931-8297 for a free estimate.
Can you come today if my door is stuck open?
Yes – a door stuck open or an opener failure that traps your car is exactly what our emergency service is for. Same-day repair is often available. Call (877) 931-8297. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Pricing reflects the Melrose market as of 2026. Garage Door Repair Mott Haven offers free estimates – call (877) 931-8297.
Written by the team at Garage Door Repair Mott Haven.
What Our Customers Say
"Fixed the spring properly and the door works fine. He did leave the old spring and some hardware by the side of the house, and I had to text to ask about hauling it off. They came back for it, just took a couple of days."
- Laura Anderson"Opener kept reversing halfway down. Turned out to be the safety sensors knocked out of alignment by a bicycle. He straightened them, wouldn't charge me for it, and just asked me to keep them in mind if I need real work later."
- Roger Norris"Both cables had come off the drum and the door was hanging crooked. I'd watched a video and was about ten minutes from trying it myself, which the tech told me would have been a genuinely bad idea. Glad I called."
- Marcy Vaughn